2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT LEVEL WARNING SWITCH ASSEMBLY

  1. E152498E01
    Remove the washer jar.

  1. Disconnect the level warning switch connector.

    HINT:
    The check should be performed with the level warning switch assembly installed to the washer jar.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (SLR1) - 2 (E)
    Washer jar is full
    10 kΩ or higher
    1 (SLR1) - 2 (E)
    Washer jar is empty
    Below 1 Ω

    If the result is not as specified, replace the level warning switch assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →