2007-2013 Highlander Kluger · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from May 2007


1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY

  1. B170937
    Install the rear No. 1 seat inner belt assembly with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


2. INSTALL REAR NO. 1 SEAT ASSEMBLY

  1. B173764
    Temporarily install the 2 bolts on the front side of the seat.

  1. B173774
    Temporarily Install the 3 bolts on the rear side of the seat.

  1. Install the rear No. 1 seat assembly with the 5 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


3. CONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY (w/ Remote Folding Function)

  1. Remove the rear seat reclining control cable from the carpet hole.

    B180394E01

  1. Connect the rear seat reclining control cable as shown in the illustration.

  1. Connect the rear No. 1 seat lock cable assembly as shown in the illustration.

    B173769E01

  1. B173767
    Engage the 2 claws and connect the rear No. 1 seat lock cable assembly as shown in the illustration.

  1. Return the seatback to the upright position.

  1. Pull up the adjuster's lock piece to lock it as shown in the illustration.

    B180391E01

    NOTICE:
    When pressing the lock piece, make sure the adjuster's spring is not compress.


4. INSPECT REAR SEAT SLIDE ADJUSTER LOCK
  1. Check that the left and right adjusters lock simultaneously when sliding the seat.

  1. If the left and right adjusters do not lock simultaneously, adjust by loosening the bolts securing the seat.


5. INSTALL REAR SEAT LEG SIDE COVER

  1. B173765
    Engage the clip.

  1. Engage the 3 claws and install the rear seat leg side cover.


6. INSTALL REAR INNER TRACK BRACKET COVER

  1. B173761
    Engage the 4 claws and install the rear inner track bracket cover.


7. INSTALL REAR OUTER TRACK BRACKET COVER

  1. B173763
    Engage the 4 claws and install the rear outer track bracket cover.


8. INSTALL REAR SEAT TRACK BRACKET COVER

  1. B173760
    Engage the 8 claws and install the 2 seat track bracket covers.


9. INSTALL REAR SEAT HEADREST ASSEMBLY
← REMOVAL (from May 2007)COMPONENTS (May 2007 – Jun 2010) →