C1436 Yaw Rate Sensor Malfunction
Diagnostic trouble codes · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are set.
These DTCs are also output when calibration has not been completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1436 |
Either of the following is detected:
|
Yaw rate and acceleration sensor |
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate and acceleration sensor, perform zero point calibration (Click here).
- HINT:
- When U0123, U0124 and/or U0126 is output together with C1436, inspect and repair the trouble areas indicated by U0123, U0124 and/or U0126 first (Click here).
| 1. READ VALUE ON INTELLIGENT TESTER (YAW RATE AND ACCELERATION SENSOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select the Data List mode on the intelligent tester (Click here).
ABS / VSC / TRC: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Yaw Rate Sensor
Yaw rate sensor / min.: -128 °/s, max.: 127 °/s
Vehicle stationary: 0 °/s
Right turn: -128 to 0 °/s
Left turn: 0 to 127 °/s
-
Yaw Rate Sensor2
Yaw rate sensor 2 / min.: -128 °/s, max.: 127 °/s
Vehicle stationary: 0 °/s
Right turn: -128 to 0 °/s
Left turn: 0 to 127 °/s
-
Check that the yaw rate and acceleration sensor output value displayed on the intelligent tester.
- Result:
Result
Proceed to
NG (The yaw rate and acceleration sensor output value is 0 °/s when the vehicle is stationary, but the value fluctuates when turning)
A
NG (The yaw rate and acceleration sensor output value is not 0 °/s when the vehicle is stationary)
B
OK
C
- NOTICE:
- Check the yaw rate and acceleration sensor signal after replacement (Click here).
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
|
|
||||
|
|
||||
| A | |
| 2. CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor has been installed properly (Click here).
- OK:
- The sensor should be tightened to the specified torque.
- The sensor should not be installed in a tilted position.
- NOTICE:
- Check the yaw rate and acceleration sensor signal after replacement (Click here).
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
|
|
||||
| OK | ||
| ||
