2007-2013 Highlander Kluger · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A162365
    Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 clips on the front of the V-bank cover sub-assembly. Continue rising the V-bank cover sub-assembly to disengage the clip on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the V-bank cover sub-assembly to break.


2. REMOVE PCV HOSE

  1. A175273E01
    Disconnect the PCV hose from the PCV valve.


3. REMOVE VENTILATION VALVE SUB-ASSEMBLY

  1. A175274E01
    Remove the PCV valve.

← COMPONENTS (from May 2007)REMOVAL (Aug 2008 – Jun 2010) →