2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT PURGE VSV

  1. Check the VSV for an open circuit.

    1. A128939E03
      Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      23 to 26 Ω at 20°C (68°F)
      1 - Body ground
      2 - Body ground
      10 MΩ or higher

      If the result is not as specified, replace the VSV.

  1. Check operation of the VSV.

    1. A128937E01
      Check that air does not flow from the port F as shown in the illustration.
      If the result is not as specified, replace the VSV.

    2. Apply battery positive voltage across the terminals.

    3. A128938E01
      Check that air flows from the port F as shown in the illustration.
      If the result is not as specified, replace the VSV.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →