2007-2013 Highlander Kluger · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY

  1. B174569
    Engage the 2 clamps and install the seat heater control sub-assembly.

  1. Connect the 2 connectors.


2. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the connectors under the seat.

  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When reconnected the cable, some systems need to be initialized (Click here).

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Operate the power seat switch knob and move the seat to the rearmost position.

  1. B174582E01
    Tighten the 2 bolts on the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.

  1. Operate the power seat switch knob and move the seat to the foremost position.

  1. B174581E01
    Tighten the 2 bolts on the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.


3. INSTALL REAR INNER SEAT TRACK COVER

  1. B172844
    Engage the 2 claws and install the rear inner seat track cover.


4. INSTALL REAR OUTER SEAT TRACK COVER

  1. B172843
    Engage the 2 claws and install the rear outer seat track cover.


5. INSTALL FRONT INNER SEAT TRACK COVER
  1. Operate the power seat switch knob and move the seat to the rearmost position.

  1. B172842
    Engage the 2 claws and install the front inner seat track cover.


6. INSTALL FRONT OUTER SEAT TRACK COVER

  1. B172841
    Engage the 2 claws and install the front outer seat track cover.


7. INSTALL FRONT SEAT HEADREST ASSEMBLY

8. INSPECT FRONT SEAT ASSEMBLY
  1. Inspect the power seat operation.

  1. w/ Seat Heater System:
    Check the seat heater operation.

    1. Turn the ignition switch on (IG).

    2. Turn the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.


9. INSPECT SRS WARNING LIGHT
(Click here)
← INSTALLATION (Aug 2008 – Jun 2010)PRECAUTION (May 2007 – Jul 2008) →