2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

CUSTOMIZE PARAMETERS

Troubleshooting · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that customization of the function(s) is possible.
  2. Be sure to record the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is not set to OFF.


CUSTOMIZE
  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus:
    Select: Body / MAIN BODY or Entry&Start / Utility / Customize /

  5. Select the setting by referring to the table below.

MAIN BODY (Main body ECU) 
Display (Item)
Default
Contents
Setting
Wireless Control
ON
ON/OFF of wireless door lock function
ON/OFF
Hazard Answer Back
ON
When LOCK switch on transmitter pressed, all hazard warning lights illuminate once. When UNLOCK switch pressed, all hazard warning lights illuminate twice
ON/OFF
Wireless Buzzer Resp*
ON
Function that makes wireless buzzer sound for answer-back when transmitter LOCK/UNLOCK switch pressed
ON/OFF
Open Door Warning*
ON
If door is not completely closed and transmitter LOCK switch is pressed, this function sounds a buzzer for 10 seconds
ON/OFF
Unlock 2 Operation*
OFF
Function that unlocks driver side door when unlock switch on transmitter is pressed once, and unlocks all doors when pressed twice. If setting is OFF, pressing unlock switch once makes all doors unlock.
ON/OFF
Auto Lock Time
30s
This function controls amount of time from unlocking doors to automatic re-locking function
30s/60s/120s

HINT:
*: for RHD

Entry&Start (Certification ECU (Smart Key ECU Assembly)) 
Display (Item)
Default
Contents
Setting
Panic Alarm Function*
ON
Function to operate theft deterrent system by continuously pressing panic switch on transmitter for 0.8 seconds
ON/OFF

HINT:
*: for RHD

← OPERATION CHECK (from Jul 2010)CUSTOMIZE PARAMETERS (from Jul 2010) →