2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT FRONT ENGINE MOUNTING INSULATOR ASSEMBLY
  1. Inspect the front engine mounting insulator assembly.

    1. Connect the intelligent tester to the DLC3.

    2. Start the engine and turn the intelligent tester on.

    3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the ACM Inhibit.

      Tester Display
      Test Part
      Control Range
      Diagnostic Note
      Control the ACM Inhibit
      ACM
      ON / OFF
      Test is possible while engine is idling

    4. Check if the front engine mounting insulator assembly operates in accordance with tester operation.

      Standard:
      The front engine mounting insulator assembly operates normally in accordance with tester operation.

← COMPONENTS (from Jul 2010)REMOVAL (May 2007 – Jul 2008) →