2007-2013 Highlander Kluger · Service Manual BODY

Power Back Door cannot be Closed Using the Power Back Door Closer Switch

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

When the power back door cannot be closed using the power back door closer switch, one of the following may be malfunctioning: 1) power back door closer switch circuit, or 2) power back door drive unit (power back door ECU).

WIRING DIAGRAM

B165217E04

INSPECTION PROCEDURE


1. READ VALUE ON INTELLIGENT TESTER
  1. Check the Data List to determine if the power back door closer switch functions properly.

    Back door (Power back door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PBD Close SW
    Power back door closer switch signal / ON or OFF
    ON: Power back door closer switch ON
    OFF: Power back door closer switch OFF
    -

    OK:
    The power back door closer switch functions as specified in the normal condition.



NG
Go to step 2
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)

2. INSPECT POWER BACK DOOR CLOSER SWITCH

  1. B165201E02
    Remove the power back door closer switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Pushed (ON)
    Below 1 Ω
    1 - 2
    Free (OFF)
    10 kΩ or higher



NG
REPLACE POWER BACK DOOR CLOSER SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (POWER BACK DOOR CLOSER SWITCH - POWER BACK DOOR DRIVE UNIT)

  1. B165212E03
    Disconnect the T10 switch connector.

  1. Disconnect the O14 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T10-1 - O14-4 (DS1)
    Always
    Below 1 Ω
    T10-2 - Body ground
    Always
    Below 1 Ω
    T10-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)


← Power Back Door cannot be Opened or Closed Using the Power Back Door Switch (from Jul 2010)Power Back Door cannot be Closed Using the Power Back Door Closer Switch (Aug 2008 – Jun 2010) →