2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT NO. 2 IGNITION RELAY

  1. B016200
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    No battery voltage applied
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.

← ON-VEHICLE INSPECTION (from May 2007)ON-VEHICLE INSPECTION (from May 2007) →