2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE STEERING COLUMN COVER

  1. E151100
    Turn the steering wheel assembly to the right and remove the screw as shown in the illustration.

  1. E151101
    Turn the steering wheel assembly to the left and remove the screw as shown in the illustration.

  1. E151095
    Disengage the 2 claws and remove the lower steering column cover.

  1. E151094
    Disengage the claw and remove the upper steering column cover.


2. REMOVE KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System)

  1. C172130
    Using a screwdriver, widen the claws hanging onto the upper bracket by approximately 1.0 mm (0.039 in.).

  1. Pull out the key cylinder light assembly with the claw open.

    NOTICE:
    Using excessive force may damage the case.


3. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)

  1. C115569
    Using a screwdriver, widen the claws hanging onto the upper bracket by approximately 1.0 mm (0.039 in.).

  1. Pull out the transponder key amplifier with the claw open.

    NOTICE:
    Using excessive force may damage the case.

← COMPONENTS (from May 2007)REMOVAL (from Jul 2010) →