2007-2013 Highlander Kluger · Service Manual BRAKE

C1440 Unusual Bank Angle Detected

Diagnostic trouble codes · Vehicles built from Jul 2010

DESCRIPTION

If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes.
DTC Code
DTC Detection Condition
Trouble Area
C1440
Driving at a steep bank angle.
Yaw rate and acceleration sensor

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC (C1440) is output
    A
    DTC (C1440) is not output
    B
    Yaw rate and acceleration sensor DTC is output
    C



B
END

C
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)
A


2. CLEAR DTC
  1. Clear the DTCs (Click here).

    HINT:
    1. If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440 while VSC operation is temporarily disabled.
    2. It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes.


NEXT

END


← C1439 Steering Angle Sensor Initialization Incomplete (+ C1445) (from Jul 2012)C1440 Steering Angle Sensor Unusual Bank Angle Detected (Aug 2008 – Jun 2010) →