2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

REASSEMBLY

Removal / installation · Vehicles built May 2007 – Jun 2010


1. PRECAUTION (for LHD)

NOTICE:
When reassembling the air conditioning control assembly, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.


2. INSTALL HEATER CONTROL KNOB (for LHD)

  1. E226225E01
    Passenger Side:

    1. Check that the spring is installed in the heater control knob.

      HINT:
      If the spring is still attached to the heater control base sub-assembly, remove it from the heater control base sub-assembly and install it to the heater control knob.

    2. Install the heater control knob.

  1. E226226E01
    Driver Side:

    1. Check that the spring is installed in the heater control knob.

      HINT:
      If the spring is still attached to the heater control base sub-assembly, remove it from the heater control base sub-assembly and install it to the heater control knob.

    2. Install the heater control knob.


3. INSTALL REAR CONTROL PANEL CASE (for LHD)

  1. E226606
    Check that the rubber sheet and pins of the control panel sub-assembly are engaged.

    HINT:
    Make sure that the rubber sheet is engaged with the pins at the positions shown in the illustration.

  1. Install the heater control base sub-assembly with heater control knob.

  1. E226219
    Install the rear control panel case with the 8 screws.

← DISASSEMBLY (May 2007 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →