PARK / NEUTRAL POSITION SWITCH > INSPECTION |
| 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Jack up the vehicle.
![]() |
Disconnect the park/neutral position switch connector.
Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.
| Tester Connection | Shift Position | Specified Condition |
| 4 - 5 | P and N | Below 1 Ω |
| Except P and N | 10 kΩ or higher | |
| 2 - 6 | P | Below 1 Ω |
| Except P | 10 kΩ or higher | |
| 2 - 1 | R | Below 1 Ω |
| Except R | 10 kΩ or higher | |
| 2 - 9 | N | Below 1 Ω |
| Except N | 10 kΩ or higher | |
| 2 - 7 | D, S, "+" and "-" | Below 1 Ω |
| Except D, S, "+" and "-" | 10 kΩ or higher |