Home › TRANSMISSION · U151F AUTOMATIC TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Jack up the vehicle.



    C110340E91
  1. Disconnect the park/neutral position switch connector.

  1. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

    Standard resistance:
    Tester Connection
    Shift Position
    Specified Condition
    4 - 5
    P and N
    Below 1 Ω
    Except P and N
    10 kΩ or higher
    2 - 6
    P
    Below 1 Ω
    Except P
    10 kΩ or higher
    2 - 1
    R
    Below 1 Ω
    Except R
    10 kΩ or higher
    2 - 9
    N
    Below 1 Ω
    Except N
    10 kΩ or higher
    2 - 7
    D, S, "+" and "-"
    Below 1 Ω
    Except D, S, "+" and "-"
    10 kΩ or higher

    If the resistance value is not as specified, replace the park/neutral position switch.