Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT DISC BRAKE PAD


    C165873
  1. Remove the 2 anti-squeal springs.



    C165872
  1. Remove the 2 brake pads from the front disc brake cylinder mounting.



2. REMOVE FRONT ANTI-SQUEAL SHIM
  1. Remove the 2 anti-squeal shims and the 2 pad wear indicators from the pads.



3. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE


    C165874
  1. Remove the 4 front disc brake pad support plates from the front disc brake cylinder mounting.

    NOTICE:
    Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that they can be reinstalled to their original position.



4. REMOVE NO. 1 FRONT DISC BRAKE CYLINDER SLIDE PIN


    C165877
  1. Remove the No. 1 front disc brake cylinder slide pin from the front disc brake cylinder mounting.



5. REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN


    C165878
  1. Remove the No. 2 front disc brake cylinder slide pin from the front disc brake cylinder mounting.



6. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSHING


    C132797E01
  1. Using a screwdriver, remove the front disc brake cylinder slide bushing from the No. 2 front disc brake cylinder slide pin.

    NOTICE:
    Do not damage the No. 2 front disc brake cylinder slide pin.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE FRONT DISC BRAKE BUSHING DUST BOOT


    C165876
  1. Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.



8. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING


    C165875
  1. Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.



9. REMOVE FRONT DISC BRAKE PISTON


    C165880
  1. Place a shop rag or a piece of cloth between the disc brake pistons and the disc brake cylinder assembly.

  1. Using compressed air, remove one of the disc brake pistons from the disc brake cylinder assembly.

    CAUTION:
    Do not place your fingers in front of the front disc brake piston when using compressed air.

    NOTICE:
    Do not allow any brake fluid to spatter.



10. REMOVE CYLINDER BOOT


    C165881E01
  1. Using a screwdriver, remove the 2 cylinder boots.

    NOTICE:
    Be careful not to damage the front disc brake cylinder.

    HINT:
    Tape the screwdriver tip before use.



11. REMOVE PISTON SEAL


    C165882E01
  1. Using a screwdriver, remove the 2 piston seals from the disc brake cylinder assembly.

    NOTICE:
    Be careful not to damage the inner cylinder or cylinder groove.

    HINT:
    Tape the screwdriver tip before use.



12. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


13. REMOVE FRONT DISC BRAKE BLEEDER PLUG


14. REMOVE FRONT DISC


    C165879E01
  1. Remove the front disc.

    HINT:
    Put matchmarks on the disc and the axle hub.