Home › DRIVE LINE › DRIVE SHAFT › REAR DRIVE SHAFT (for 4WD)

REAR DRIVE SHAFT (for 4WD) > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR DRIVE SHAFT SNAP RING


    C057543E04
  1. Using a screwdriver, remove the rear drive shaft snap ring.



2. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP


    C166351
  1. Using pliers, remove the rear drive shaft inboard joint boot clamp as shown in the illustration.



3. REMOVE NO. 2 REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP


    C166350
  1. Using pliers, remove the No. 2 rear drive shaft inboard joint boot clamp as shown in the illustration.



4. SEPARATE INBOARD JOINT BOOT
  1. Separate the rear drive shaft inboard joint boot from the inboard joint assembly.



5. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY
  1. Remove the grease from the inboard joint assembly.



    C166352E01
  1. Put matchmarks on the rear drive shaft inboard joint assembly and rear drive shaft outboard joint shaft assembly.

    NOTICE:
    Do not use a punch for the marks.

  1. Remove the rear drive shaft inboard joint assembly from the rear drive shaft outboard joint shaft assembly.



    C166353
  1. Using a snap ring expander, remove the snap ring.



    C166354E01
  1. Put matchmarks on the rear drive shaft outboard joint shaft assembly and tripod joint.

    NOTICE:
    Do not use a punch for the marks.

  1. Using a brass bar and hammer, remove the tripod joint from the outboard joint shaft assembly.

    NOTICE:
    Do not tap the roller.

  1. Remove the inboard joint boot, rear drive shaft inboard joint boot clamp and No. 2 rear drive shaft inboard joint boot clamp.



6. REMOVE REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP


    C166356
  1. Using pliers, remove the rear drive shaft outboard joint boot clamp as shown in the illustration.



7. REMOVE NO. 2 REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP


    C166355
  1. Using pliers, remove the No. 2 rear drive shaft outboard joint boot clamp as shown in the illustration.



8. REMOVE OUTBOARD JOINT BOOT
  1. Remove the outboard joint boot from the outboard joint shaft assembly.

  1. Remove the old grease from the rear drive outboard joint shaft assembly.

    NOTICE:
    Do not disassemble the outboard joint.



9. REMOVE REAR DRIVE SHAFT DUST COVER


    C166357E01
  1. Using SST and a press, remove the rear drive shaft dust cover.

    SST
    09950-00020  

    NOTICE:
    Be careful not to drop the rear drive shaft inboard joint assembly. Do not overtighten SST.