CYLINDER BLOCK > DISASSEMBLY |
| 1. REMOVE PISTON SUB-ASSEMBLY WITH CONNECTING ROD |
Check that the matchmarks on the connecting rod sub-assembly and connecting rod cap are aligned.
![]() |
Remove the 2 connecting rod cap bolts.
![]() |
Using the 2 removed connecting rod cap bolts, remove the connecting rod cap and lower bearing by wiggling the connecting rod cap right and left.
![]() |
Using a ridge reamer, remove all the carbon from the top of the cylinder.
Push the piston, connecting rod assembly and upper bearing through the top of the cylinder block.
| 2. REMOVE CONNECTING ROD BEARING |
| 3. REMOVE PISTON RING SET |
![]() |
Using a piston ring expander, remove the 2 compression rings.
Remove the oil ring expander and 2 side rails by hand.
| 4. REMOVE PISTON SUB-ASSEMBLY WITH PIN |
![]() |
Check the fitting condition between the piston and piston pin.
Try to move the piston back and forth on the piston pin.
If any movement is felt, replace the piston and pin as a set.
![]() |
Disconnect the connecting rod from the piston.
Using a screwdriver, pry off the piston pin hole snap rings from the piston.
![]() |
Gradually heat the piston to approximately 80°C (176°F).
![]() |
Using a brass bar and plastic hammer, lightly tap out the piston pin and remove the connecting rod sub-assembly.
![]() |
Using a gasket scraper, remove the carbon from the piston top.
![]() |
Using a groove cleaning tool or broken ring, clean the piston ring grooves.
![]() |
Using solvent and a brush, thoroughly clean the piston.
| 5. REMOVE CRANKSHAFT |
![]() |
Uniformly loosen and remove the 8 crankshaft bearing cap bolts and the 8 seal washers in several steps and in the sequence shown in the illustration.
![]() |
Uniformly loosen the 16 crankshaft bearing cap bolts, in several steps and in the sequence shown in the illustration.
![]() |
Using a screwdriver, pry out the crankshaft bearing caps. Remove the 4 crankshaft bearing caps and lower crankshaft bearings.
Remove the crankshaft.
| 6. REMOVE CRANKSHAFT BEARING |
Remove the upper crankshaft bearing and lower crankshaft bearing.
| 7. REMOVE CRANKSHAFT THRUST WASHER SET |
![]() |
Remove the upper crankshaft bearings and upper crankshaft thrust washers from the cylinder block sub-assembly.
| 8. REMOVE NO. 1 OIL NOZZLE SUB-ASSEMBLY |
![]() |
Using a 5 mm hexagon wrench, remove the bolts and No. 1 oil nozzle sub-assembly.
Check the 3 oil nozzles for damage or clogging.
If necessary, replace the No. 1 oil nozzle sub-assembly.
| 9. CLEAN CYLINDER BLOCK |