CYLINDER HEAD > REPLACEMENT |
| 1. REPLACE INTAKE VALVE GUIDE BUSH |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the intake valve guide bushes.
![]() |
Using a caliper gauge, measure the intake valve guide bush bore diameter of the cylinder head.
| Bush size | Bush bore diameter |
| STD | 10.285 to 10.306 mm (0.4049 to 0.4057 in.) |
| O/S 0.05 | 10.335 to 10.356 mm (0.4069 to 0.4077 in.) |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST, tap in new intake valve guide bushes to the specified protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the valve guide bushings to obtain the specified clearance.
| 2. REPLACE EXHAUST VALVE GUIDE BUSH |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
Using SST and hammer, tap out the exhaust valve guide bushes.
![]() |
Using a caliper gauge, measure the exhaust valve guide bush bore diameter of the cylinder head.
| Bush size | Bush bore diameter |
| STD | 10.285 to 10.306 mm (0.4049 to 0.4057 in.) |
| O/S 0.05 | 10.335 to 10.356 mm (0.4069 to 0.4077 in.) |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST, tap in new exhaust valve guide bushes to the specified protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the valve guide bushings to obtain the specified clearance.
| 3. REPLACE RING PIN |
![]() |
Using a plastic hammer, tap in new ring pins to the specified protrusion height.
| 4. REPLACE STUD BOLT |
Using E6 and E8 "TORX" sockets, install the stud bolts.

| 5. REPLACE STRAIGHT PIN |
Using a plastic hammer, tap in new straight pins as shown in the illustration.
