CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL NO. 1 STRAIGHT SCREW PLUG |
![]() |
Using a 10 mm hexagon wrench, install 4 new gaskets and the 4 No. 1 straight screw plugs.
| 2. INSTALL NO. 2 STRAIGHT SCREW PLUG |
![]() |
Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 No. 2 straight screw plugs.
| 3. INSTALL VALVE SPRING SEAT |
Install the valve spring seats to the cylinder head.
| 4. INSTALL VALVE STEM OIL SEAL |
![]() |
Apply a light coat of engine oil to new valve stem oil seals.
![]() |
Using SST, push in the oil seals.
| 5. INSTALL EXHAUST VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the exhaust valve shown in the illustration.
Install the exhaust valve, inner compression spring and valve spring retainer to the cylinder head.
![]() |
Using SST, compress the inner compression spring and install the 2 valve spring retainer locks.
![]() |
Using a plastic hammer, lightly tap the valve stem tip to ensure a proper fit.
| 6. INSTALL INTAKE VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the intake valve shown in the illustration.
Install the intake valve, inner compression spring and valve spring retainer to the cylinder head.
![]() |
Using SST, compress the inner compression spring and install the 2 valve spring retainer locks.
![]() |
Using a plastic hammer, lightly tap the valve stem tip to ensure a proper fit.
| 7. INSTALL VALVE STEM CAP |
Apply a light coat of engine oil to the valve stem caps.
Install the valve stem caps on the valves.