Home › ENGINE › 2GR-FE ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE ENGINE UNDER COVER ASSEMBLY


    A171849
  1. Remove the 2 bolts and engine under cover assembly RR.



    A171850
  1. Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.



3. REMOVE NO. 1 ENGINE UNDER COVER


    A171855
  1. Remove the 6 bolts, 2 clips and No. 1 engine under cover.



4. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH


    A176043
  1. Remove the clip.

  1. Using a 4 mm hexagon wrench, remove the screw.



    A176044
  1. Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly RH.

  1. Remove the pad from the front fender moulding sub-assembly RH.

  1. Remove the 2 clips No. 4 from the front fender moulding sub-assembly RH.



    A176045
  1. Remove the front fender side protector from the front fender moulding sub-assembly RH.



5. REMOVE FRONT FENDER LINER RH


    B174753E01
  1. Remove the screw.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.



    B174750
  1. Using a 4 mm hexagon wrench, remove the 2 screws.

  1. Remove the 2 grommets.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.



    B174752
  1. Remove the 5 clips, 7 screws and front fender liner RH.



6. REMOVE FRONT FENDER APRON SEAL RH


    A171853
  1. Remove the 2 bolts, clip and front fender apron seal RH.



7. REMOVE V-RIBBED BELT


    A162386E01
  1. Using SST, release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, and remove the V-ribbed belt from the V-ribbed belt tensioner assembly.

    SST
    09961-00950  



    A095070
  1. While turning the V-ribbed belt tensioner assembly counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner assembly.