Home › BODY › SEAT › POWER SEAT SWITCH

POWER SEAT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT FRONT POWER SEAT SWITCH (DRIVER SIDE)


    B105970E20
  1. Measure the resistance between the terminals when each switch is operated.

    Standard resistance:
    Slide switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 9 (SLDF)
    FRONT
    Below 1 Ω
    4 (E) - 6 (SLDR)
    FRONT
    Below 1 Ω
    4 (E) - 6 (SLDR)
    OFF
    Below 1 Ω
    4 (E) - 9 (SLDF)
    OFF
    Below 1 Ω
    1 (B) - 6 (SLDR)
    REAR
    Below 1 Ω
    4 (E) - 9 (SLDF)
    REAR
    Below 1 Ω
    Front vertical switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 10 (FUP)
    UP
    Below 1 Ω
    4 (E) - 5 (FDWN)
    UP
    Below 1 Ω
    4 (E) - 5 (FDWN)
    OFF
    Below 1 Ω
    4 (E) - 10 (FUP)
    OFF
    Below 1 Ω
    1 (B) - 5 (FDWN)
    DOWN
    Below 1 Ω
    4 (E) - 10 (FUP)
    DOWN
    Below 1 Ω
    Lifter switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 7 (LUP)
    UP
    Below 1 Ω
    4 (E) - 8 (LDWN)
    UP
    Below 1 Ω
    4 (E) - 7 (LUP)
    OFF
    Below 1 Ω
    4 (E) - 8 (LDWN)
    OFF
    Below 1 Ω
    1 (B) - 8 (LDWN)
    DOWN
    Below 1 Ω
    4 (E) - 7 (LUP)
    DOWN
    Below 1 Ω
    Reclining switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 3 (RCLF)
    FRONT
    Below 1 Ω
    2 (RCLR) - 4 (E)
    FRONT
    Below 1 Ω
    2 (RCLR) - 4 (E)
    OFF
    Below 1 Ω
    3 (RCLF) - 4 (E)
    OFF
    Below 1 Ω
    1 (B) - 2 (RCLR)
    REAR
    Below 1 Ω
    3 (RCLF) - 4 (E)
    REAR
    Below 1 Ω

    If the result is not as specified, replace the switch.



2. INSPECT FRONT POWER SEAT SWITCH (PASSENGER SIDE)


    B129637E03
  1. Measure the resistance between the terminals when each switch is operated.

    Standard resistance:
    Slide switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 9 (SLDF)
    FRONT
    Below 1 Ω
    4 (E) - 6 (SLDR)
    FRONT
    Below 1 Ω
    4 (E) - 6 (SLDR)
    OFF
    Below 1 Ω
    4 (E) - 9 (SLDF)
    OFF
    Below 1 Ω
    1 (B) - 6 (SLDR)
    REAR
    Below 1 Ω
    4 (E) - 9 (SLDF)
    REAR
    Below 1 Ω
    Reclining switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 3 (RCLF)
    FRONT
    Below 1 Ω
    2 (RCLR) - 4 (E)
    FRONT
    Below 1 Ω
    2 (RCLR) - 4 (E)
    OFF
    Below 1 Ω
    3 (RCLF) - 4 (E)
    OFF
    Below 1 Ω
    1 (B) - 2 (RCLR)
    REAR
    Below 1 Ω
    3 (RCLF) - 4 (E)
    REAR
    Below 1 Ω

    If the result is not as specified, replace the switch.