POWER DOOR LOCK CONTROL SYSTEM > Only Passenger Door LOCK / UNLOCK Functions do not Operate |

| 1.INSPECT FRONT DOOR LOCK ASSEMBLY |
![]() |
Remove the front passenger side door lock assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Measurement Condition | Door Lock Condition | Specified Condition |
| 7 - 8 | Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Locked | 10 kΩ or higher |
| 7 - 8 | Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlocked | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK MOTOR CIRCUIT) |
![]() |
Disconnect the instrument panel junction block connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G8-1 (UL) - 1J-2 | Always | Below 1 Ω |
| G8-4 (L) - 1J-1 | Always | Below 1 Ω |
| G8-1 (UL) - Body ground | Always | 10 kΩ or higher |
| G8-4 (L) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (DOOR UNLOCK DETECTION SWITCH CIRCUIT) |
![]() |
Disconnect the main body ECU (instrument panel junction block) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G8-7 (LSSR) - D7-27 (LSWP) | Always | Below 1 Ω |
| G8-7 (LSSR) - Body ground | Always | 10 kΩ or higher |
| G8-8 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||