Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Only Rear Door RH LOCK / UNLOCK Functions do not Operate

for Preparation Click here


DESCRIPTION

The main body ECU (instrument panel junction block) receives lock/unlock switch signals and activates the door lock motor according to these signals.

WIRING DIAGRAM


B164398E20


B171383E02


INSPECTION PROCEDURE

1.INSPECT REAR DOOR LOCK ASSEMBLY


    B164416E01
  1. Remove the rear door lock assembly RH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Measurement Condition
    Door Lock Condition
    Specified Condition
    6 - 9
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Locked
    10 kΩ or higher
    6 - 9
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlocked
    Below 1 Ω



NG
REPLACE REAR DOOR LOCK ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (REAR DOOR LOCK MOTOR CIRCUIT)


    B171384E01
  1. Disconnect the instrument panel junction block connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J4-1 (UL) - 1F-18
    Always
    Below 1 Ω
    J4-4 (L) - 1F-5
    Always
    Below 1 Ω
    J4-1 (UL) - Body ground
    Always
    10 kΩ or higher
    J4-4 (L) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (DOOR UNLOCK DETECTION SWITCH CIRCUIT)


  1. Disconnect the main body ECU (instrument panel junction block) (*1) or instrument panel junction block (*2) connector.

    HINT:
    1. *1: w/ Smart Key System, Power Back Door System and Glass Hatch Opener System
    2. *2: w/o Smart Key System, Power Back Door System and Glass Hatch Opener System


    B171385E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J4-6 (LSSR) - D7-5 (LSWR) (*1)
    Always
    Below 1 Ω
    J4-6 (LSSR) - 1L-5 (*2)
    Always
    Below 1 Ω
    J4-6 (LSSR) - Body ground
    Always
    10 kΩ or higher
    J4-9 (E) - Body ground
    Always
    Below 1 Ω

    HINT:
    1. *1: w/ Smart Key System, Power Back Door System and Glass Hatch Opener System
    2. *2: w/o Smart Key System, Power Back Door System and Glass Hatch Opener System



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)