AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
![]() |
Measure the line pressure.
Warm up the ATF (Automatic Transmission Fluid).
Lift the vehicle up.
Remove the engine under cover.
Connect Techstream to the DLC3.
Remove the test plug A on the transaxle case front left side and install the SST.
Start the engine.
Using Techstream, shift to D position and hold 3rd gear by active test, and measure the line pressure in idling.
| Condition | D position kPa (kgf / cm2, psi) |
| Idling | 372 to 412 kPa (3.8 to 4.2 kgf/cm2, 54 to 60 psi) |
Turn the ignition switch off.
![]() |
Disconnect the connector of the transmission wire.
Start the engine.
Firmly depress the brake pedal, shift to the D position, depress the accelerator pedal all the way down and check the line pressure while the stall test is performed.
| Condition | D position kPa (kgf / cm2, psi) |
| Stall test | 931 to 1031 kPa (9.5 to 10.5 kgf/cm2, 135 to 150 psi) |
Turn the ignition switch off.
Remove the SST, install the test plug A.
Remove the test plug B, install the SST and start engine.
Connect the transmission wire connector, depress the brake pedal firmly, shift to the R position and check that the line pressure while the engine is idling and during the stall test.
| Condition | R position kPa (kgf / cm2, psi) |
| Idling | 672 to 742 kPa (6.9 to 7.6 kgf/cm2, 97 to 108 psi) |
| Stall test | 1768 to 1968 kPa (18.0 to 20.1 kgf/cm2, 256 to 285 psi) |
Remove the SST, install the test plug B.
Clear the DTC.
| Problem | Possible cause |
| Measured values are higher than specified in all positions |
|
| Measured values are lower than specified in all positions |
|
| Pressure is low in the D position only |
|
| Pressure is low in the R position only |
|