Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL-SAFE FUNCTION
  1. When communication fails in any of the CAN bus wires (communication wires) due to a short circuit or other causes, the fail-safe function, which is specified for each system, operates to prevent the system from malfunctioning.

  2. The following chart shows the relationships between components, system functions, and effects of communication failure on these functions. (For further details, see the pages for each system.)

    Function
    (Function Description)
    Control Master
    System Related
    Fail-safe Operation
    DTC
    (Driver Detectable)
    VSC control
    (Controls driving force while VSC in operation)
    Skid Control ECU
    1. ECM
    2. Steering Angle Sensor
    3. Yaw Rate Sensor
    VSC control is inoperative
    (VSC control gradually stops)
    U0073, U0100, U0123, U0124, U0126
    (Warning light comes on)
    VSC control
    (Engine power control by VSC/TRC)
    Skid Control ECU
    1. ECM
    2. Steering Angle Sensor
    3. Yaw Rate Sensor
    VSC control is inoperative
    (VSC control gradually stops)
    U0073, U0100, U0123, U0124, U0126
    (Warning light comes on)
    Electric power steering
    (Speed of vehicle induction type torque control)
    Power Steering ECU
    1. ECM
    2. Skid Control ECU
    Depression of EPS assist
    (Deterioration of steering)
    U0100, U0129
    (VSC failure: warning light comes on, and decrease of assistance power at vehicle speed 120 km/h [74mph])
    (ECM failure : Warning light comes on [only before assist beginning])
    Meter display (Displays operation condition and DTCs)
    Combination Meter
    1. ECM
    2. Skid Control ECU
    3. Center Airbag Sensor Assembly
    4. Certification ECU
    5. Main Body ECU
    6. Power steering ECU
    Light does not come on, illuminates abnormally, or blinks abnormally
    U0100, U0129
    (Abnormal light illuminates)
    Meter buzzer (Combination meter)
    Combination Meter
    1. ECM
    2. Skid Control ECU
    3. Center Airbag Sensor Assembly
    4. Certification ECU
    5. Main Body ECU
    Meter buzzer does not ring
    U0100, U0129
    Air conditioning control
    Air Conditioning Amplifier
    1. ECM
    2. Combination Meter
    3. Main Body ECU
    Air conditioning function and PTC heater function stop
    B1499
    (Air Conditioning is inoperative)
    Smart entry function / Power door lock control*1
    Certification ECU
    1. Combination Meter
    2. Main Body ECU
    Unlock permitted
    U0327, U1002
    (Wireless door lock cannot operate)
    *1: w/ Smart key system