Home › ENGINE › 2GR-FE STARTING › STARTER CUT RELAY

STARTER CUT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STARTER CUT RELAY


    B016200
  1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 MΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the resistance is not as specified, replace the starter cut relay.