HOOD > ADJUSTMENT |

| 1. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 11 clips and cool air intake duct seal.
| 2. REMOVE RADIATOR GRILLE |
![]() |
Put protective tape around the radiator grille.
![]() |
Remove the 2 bolts and 4 clips.
![]() |
Disengage the 6 claws and 4 guides, and remove the radiator grille.
| 3. ADJUST HOOD SUB-ASSEMBLY |
Horizontally and vertically adjust the hood.
![]() |
Loosen the 4 hinge bolts of the hood.
Adjust the clearance between the hood and front fender by moving the hood.
Tighten the 4 hinge bolts after the adjustment.
Adjust the height of the front end of the hood using the cushion rubber.
![]() |
Adjust the cushion rubbers so that the heights of the hood and fender are aligned.
Adjust the hood lock.
![]() |
Remove the hood lock nut cap.
![]() |
Loosen the 3 bolts.
Tighten the bolts after the adjustment.
![]() |
Install the hood lock nut cap.
Check that the striker can engage with the hood lock smoothly.
| 4. INSTALL RADIATOR GRILLE |
![]() |
Engage the 4 guides and 6 claws, and install the radiator grille.
![]() |
Install the 4 clips and 2 bolts.
| 5. INSTALL COOL AIR INTAKE DUCT SEAL |
![]() |
Install the cool air intake duct seal with the 11 clips.