CYLINDER HEAD > INSPECTION |
| 1. INSPECT CYLINDER HEAD SUB-ASSEMBLY |
![]() |
Using a precision straight edge and feeler gauge, measure the warpage of the contact surface of the cylinder block sub-assembly and manifolds.
| Item | Warpage |
| Cylinder head lower | 0.05 mm (0.0020 in.) |
| Intake | 0.08 mm (0.0031 in.) |
| Exhaust | 0.08 mm (0.0031 in.) |
| Item | Warpage |
| Cylinder head lower | 0.10 mm (0.0039 in.) |
| Intake | 0.10 mm (0.0039 in.) |
| Exhaust | 0.10 mm (0.0039 in.) |
| 2. INSPECT CYLINDER HEAD FOR CRACKS |
![]() |
Using a dye penetrant, check the intake ports, exhaust ports and cylinder surface for cracks.
If cracked, replace the cylinder head sub-assembly.
| 3. INSPECT INTAKE VALVE |
![]() |
Using a micrometer, measure the diameter of the valve stem.
![]() |
Using vernier calipers, measure the valve head margin thickness.
![]() |
Using vernier calipers, measure the valve's overall length.
| 4. INSPECT EXHAUST VALVE |
![]() |
Using a micrometer, measure the diameter of the valve stem.
![]() |
Using vernier calipers, measure the valve head margin thickness.
![]() |
Using vernier calipers, measure the valve's overall length.
| 5. INSPECT INTAKE VALVE SEAT |
Apply a light coat of Prussian blue to the valve face.
Lightly press the valve face against the valve seat.
![]() |
Check the valve face and valve spring seat by using the following procedure:
If Prussian blue appears around the entire valve face, the valve face is concentric. If not, replace the valve.
If Prussian blue appears around the entire valve seat, the guide and valve face are concentric. If not, resurface the valve spring seat.
Check that the valve spring seat contacts in the middle of the valve face with the width between 1.1 and 1.5 mm (0.043 and 0.059 in.).
| 6. INSPECT EXHAUST VALVE SEAT |
Apply a light coat of Prussian blue to the valve face.
Lightly press the valve face against the valve spring seat.
![]() |
Check the valve face and valve spring seat by using the following procedure:
If Prussian blue appears around the entire valve face, the valve face is concentric. If not, replace the valve.
If Prussian blue appears around the entire valve seat, the guide and valve face are concentric. If not, resurface the valve spring seat.
Check that the valve spring seat contacts in the middle of the valve face with the width between 1.1 and 1.5 mm (0.043 and 0.059 in.).
| 7. INSPECT INNER COMPRESSION SPRING |
![]() |
Using vernier calipers, measure the free length of the inner compression spring.
![]() |
Using a steel square, measure the deviation of the inner compression spring.
| 8. INSPECT VALVE GUIDE BUSH OIL CLEARANCE |
![]() |
Using a caliper gauge, measure the inside diameter of the valve guide bush.
Subtract the valve stem diameter measurement from the valve guide bush inside diameter measurement.
| Item | Clearance |
| Intake | 0.025 to 0.060 mm (0.0010 to 0.0024 in.) |
| Exhaust | 0.030 to 0.065 mm (0.0012 to 0.0026 in.) |
| Item | Clearance |
| Intake | 0.08 mm (0.0032 in.) |
| Exhaust | 0.10 mm (0.0039 in.) |