VEHICLE STABILITY CONTROL SYSTEM > CALIBRATION |
| DESCRIPTION |
| Parts to be Replaced / Operation | Necessary Operation |
| Brake actuator assembly (Skid control ECU) | Yaw rate and acceleration sensor zero point calibration |
| Yaw rate and acceleration sensor |
|
| Front wheel alignment adjustment |
|
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When Using Techstream) |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in the P position.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn Techstream on.
Select the skid control ECU to clear the zero point calibration data using Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Reset Memory.
Turn the ignition switch off.
Perform the zero point calibration of the yaw rate and acceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in the P position.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn Techstream on.
Switch the skid control ECU to Test Mode using Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Test Mode.
After Test Mode has been entered, keep the vehicle stationary on a level surface for 2 seconds or more.
![]() |
Check that the slip indicator light comes on for several seconds and then blinks in Test Mode.
Turn the ignition switch off and disconnect Techstream.
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When not Using Techstream) |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in the P position.
Turn the ignition switch on (IG).
The warning light and indicator light come on for 3 seconds to indicate that the initial check is completed.
![]() |
Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
Check that the slip indicator light comes on.
Perform the zero point calibration of the yaw rate and acceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in the P position.
![]() |
Using SST, connect terminals TS and CG of the DLC3.
Turn the ignition switch on (IG).
After Test Mode has been entered, keep the vehicle stationary on a level surface for 2 seconds or more.
![]() |
Check that the slip indicator light comes on for several seconds and then blinks in Test Mode.
Turn the ignition switch off and disconnect SST from the DLC3.