Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TIRE PRESSURE WARNING ECU

HINT:
Inspect the connectors from the back side.


E129452E21

  1. Disconnect the O11 tire pressure warning antenna and receiver connector.

  2. Measure the voltage according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D33-12 (RDA) - D33-9 (GND)
    G - W-B
    Tire pressure warning antenna and receiver signal
    Ignition switch on (IG)
    11 to 14 V

  3. Connect the O11 tire pressure warning antenna and receiver connector.

  4. Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D33-1 (CLSW) - D33-9 (GND)
    P - W-B
    Tire pressure warning reset switch
    1. Ignition switch on (IG)
    2. Tire pressure warning reset switch on
    8.5 to 15 V
    1. Ignition switch on (IG)
    2. Tire pressure warning reset switch OFF
    Below 1.5 V
    D33-2 (SPD) - D33-9 (GND)
    L - W-B
    Vehicle speed signal
    Vehicle is running
    Pulse generation (see waveform 1)
    D33-3 (TC) - D33-9 (GND)
    BR - W-B
    TC terminal
    Terminal TC is not connected
    11 to 14 V
    D33-4 (TACH) - D33-9 (GND)
    V - W-B
    Engine speed signal
    Engine is running
    Pulse generation (see waveform 2)
    D33-5 (IND) - D33-9 (GND)
    SB - W-B
    Tire pressure warning light output signal
    1. Ignition switch on (IG)
    2. Tire pressure warning light off
    Below 0.5 V
    Tire pressure warning reset switch
    After ignition switch is turned on (IG), tire pressure warning light illuminates for 3 seconds.
    0.9 to 3.2 V
    D33-6 (RF5V) - D33-9 (GND)
    LG - W-B
    Tire pressure warning antenna and receiver power source
    Ignition switch on (IG)
    4.5 to 5.5 V
    D33-7 (IG) - D33-9 (GND)
    B - W-B
    IG power source
    Ignition switch on (IG)
    11 to 14 V
    D33-9 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    D33-10 (SIL) - D33-9 (GND)
    O - W-B
    Diagnostic communication
    Ignition switch on (IG)
    8 to 14 V
    D33-11 (GND2) - D33-9 (GND)
    W - W-B
    Tire pressure warning antenna and receiver ground
    Always
    Below 1 Ω



  5. F047507E05
  6. Using an oscilloscope, check waveform 1.
    Waveform 1: 
    Item
    Contents
    Terminal
    D33-2 (SPD) - D33-9 (GND)
    Tool setting
    5 V/DIV., 20 ms./DIV.
    Vehicle condition
    While driving at approximately 12 mph (20 km/h)



  7. F047507E05
  8. Using an oscilloscope, check waveform 2.
    Waveform 2: 
    Item
    Contents
    Terminal
    D33-4 (TACH) - D33-9 (GND)
    Tool setting
    5 V/DIV., 10 ms./DIV.
    Vehicle condition
    Idling

    HINT:
    The wavelength becomes shorter as the engine speed increases.