STEERING LOCK SYSTEM > Unlock Position Sensor Signal Circuit |

| 1.INSPECT STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D11-4 (SLP1) - D11-2 (SGND) |
| Below 1 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - MAIN BODY ECU) |
![]() |
Disconnect the D11 connector from the steering lock actuator assembly.
Disconnect the D8 connector from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D11-4 (SLP1) - D8-18 (SLP) | Always | Below 1 Ω |
| D11-4 (SLP1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||