Home › ENGINE › 2GR-FE COOLING › COOLING FAN RELAY

COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FAN MAIN RELAY


    A169410
  1. Remove the FAN MAIN relay from the engine room relay block and junction block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the FAN MAIN relay.

  1. Install the FAN MAIN relay to engine room relay block and junction block.