POWER WINDOW CONTROL SYSTEM > Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch |

| 1.CHECK DTC |
Check for DTCs.
Connect Techstream to the DLC3.
By following the tester screen display, check whether any DTCs are output.
| Result | Proceed to |
| No output | A |
| DTC output | B |
|
| ||||
| A | |
| 2.READ VALUE ON TECHSTREAM (D-DOOR MOTOR) |
Use the Data List to check the function of the power window master switch.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| D P/W Auto Switch | Driver side power window AUTO switch signal / ON or OFF | ON: Driver side power window AUTO switch operates OFF: Driver side power window AUTO switch does not operate | - |
| D P/W Up Switch | Driver side power window UP switch signal / ON or OFF | ON: Driver side power window UP switch operates OFF: Driver side power window UP switch does not operate | - |
| D P/W Down Switch | Driver side power window DOWN switch signal / ON or OFF | ON: Driver side power window DOWN switch operates OFF: Driver side power window DOWN switch does not operate | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT POWER WINDOW MASTER SWITCH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 8 (U) - 1 (E) - 4 (A) | Auto UP | Below 1 Ω |
| 4 (A) - 5 (D) - 1 (E) | Auto Down | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT FUSE (DOOR NO. 2) |
Remove the DOOR NO. 2 fuse from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DOOR NO. 2 | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (MASTER SWITCH - REGULATOR MOTOR) |
![]() |
Disconnect the M1 and H1 connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M1-4 (A) - H1-4 (AUTO) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||