AIRBAG SYSTEM > SRS Warning Light does not Come ON |

| 1.CHECK BATTERY VOLTAGE |
Measure the voltage of the battery.
|
| ||||
| OK | |
| 2.CHECK CONNECTOR |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Check that the connector is properly connected to the combination meter assembly.
Disconnect the connector from the combination meter assembly.
Check that the connector terminals is not damaged.
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (COMBINATION METER ASSEMBLY - BODY GROUND) |
![]() |
Connect the negative (-) terminal cable to the battery.
Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E1-1 (IG+) - Body ground | Always | 11 to 14 V |
| E1-21 (B) - Body ground | Ignition switch on (IG) | 11 to 14 V |
| E1-22 (B2) - Body ground | Always | 11 to 14 V |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E1-18 (E3) - Body ground | Always | Below 1 Ω |
| E1-40 (E2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK SRS WARNING LIGHT |
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Connect the connector to the combination meter assembly.
Disconnect the connector from the center airbag sensor assembly.
Connect the negative (-) terminal cable to the battery.
Turn the ignition switch on (IG).
Check the SRS warning light condition.
|
| ||||
| OK | ||
| ||