Home › ENGINE › 2GR-FE STARTING › IGNITION SWITCH

IGNITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT IGNITION SWITCH ASSEMBLY


    A172122E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Between each terminal
    LOCK
    10 kΩ or higher
    4 (AM1) - 2 (ACC)
    ACC
    Below 1 Ω
    4 (AM1) - 2 (ACC)
    4 (AM1) - 1 (IG1)
    5 (AM2) - 6 (IG2)
    ON
    Below 1 Ω
    4 (AM1) - 1 (IG1)
    4 (AM1) - 3 (ST1)
    5 (AM2) - 6 (IG2)
    5 (AM2) - 7 (ST2)
    START
    Below 1 Ω

    If the result is not as specified, replace the switch assembly.