Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1000/31    Center Airbag Sensor Assembly Malfunction

for Preparation Click here


DESCRIPTION

The center airbag sensor assembly consists of the deceleration sensor, the safing sensor, the drive circuit, the diagnosis circuit, the ignition control, etc.
If the center airbag sensor assembly receives signals from the deceleration sensor, it determines whether the airbag squib and pretensioner squib should be activated.
DTC B1000/31 is recorded when a malfunction is detected in the center airbag sensor assembly.

DTC No.
DTC Detection Condition
Trouble Area
B1000/31
Center airbag sensor assembly malfunction
Center airbag sensor assembly

INSPECTION PROCEDURE

HINT:
When a trouble code is output simultaneously with B1000/31, repair the malfunction indicated by the other code (except B1000/31) first.

1.CHECK CENTER AIRBAG SENSOR ASSEMBLY


    C157589E01
  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Check the DTCs (Click here).

    OK:
    DTC B1000/31 is not output.



NG
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)