UNDERDRIVE CLUTCH > REASSEMBLY |
| 1. INSTALL UNDERDRIVE CLUTCH DRUM O-RING |
![]() |
Coat a new O-ring with ATF and install it to the underdrive clutch drum.
| 2. INSTALL UNDERDRIVE CLUTCH PISTON SET |
![]() |
Coat the underdrive clutch piston with ATF, and install it to the underdrive clutch piston drum.
| 3. INSTALL UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Install the return spring to the underdrive clutch drum.
Coat the clutch balancer with ATF.
![]() |
Install the clutch balancer to the underdrive clutch drum.
![]() |
Place SST on the clutch balancer and compress the piston return spring with a press.
Using a snap ring expander, install the snap ring to the underdrive clutch drum.
Be sure that the end gap of the snap ring is not aligned with the spring retainer claw.
![]() |
Set the end gap of the snap ring in the underdrive clutch drum as shown in the illustration.
| 4. INSTALL NO. 1 UNDERDRIVE CLUTCH DISC |
![]() |
Coat the 4 discs with ATF.
Install the 4 plates, 4 discs, and flange to the underdrive clutch drum.
| 5. INSTALL NO. 2 UNDERDRIVE CLUTCH FLANGE HOLE SNAP RING |
![]() |
Using a screwdriver, install the No. 2 underdrive clutch flange hole snap ring.
Check that the end gap of the snap ring is not aligned with one of the cutouts.
| 6. INSPECT UNDERDRIVE PACK CLEARANCE |
![]() |
Install the underdrive clutch to the transaxle case.
Install a dial indicator as shown in the illustration.
Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| Mark | Thickness | Mark | Thickness |
| 1 | 3.0 (0.118) | 4 | 3.6 (0.141) |
| 2 | 3.2 (0.126) | 5 | 3.8 (0.150) |
| 3 | 3.4 (0.134) | - | - |