Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH TECHSTREAM (REFERENCE)

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus: Customize Setting / Power Window

  5. Select the setting by referring to the table below.

    Power Window (Main Body ECU): 
    Tester Display
    Default
    Contents
    Setting
    Door Key P/W Up
    ON
    Function that raises all power windows when, with engine switch off, key is used to hold driver door key cylinder to lock position for more than 2.3 seconds
    ON/OFF
    Door Key P/W Down
    ON
    Function that lowers all power windows when, with engine switch off, key is used to hold driver door key cylinder to unlock position for more than 2.3 seconds
    ON/OFF
    P/W Down W/ Transmit
    ON
    Function that lowers all power windows when, with engine switch off, unlock switch on transmitter is pressed and held for more than 3.0 seconds
    ON/OFF