Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Daytime Running Light Relay Circuit

for Preparation Click here


DESCRIPTION

This function is designed to automatically illuminate the headlights (dimmed low beams), during the daytime to make the car more visible to other vehicles.
The main body ECU and power distributor control this function. The main body ECU transmits a turn ON signal to the power distributor and the power distributor illuminates the LO-beams using a duty control.
The daytime running lights come on when the conditions given below are met:
  1. Ignition switch on (IG).
  2. Engine speed signal input (engine running condition).
  3. Parking brake switch is OFF.
  4. Light control switch is not in DRL OFF.
  5. Light control switch is in OFF, TAIL or AUTO position (and the headlights are not turned on via the automatic light control).

WIRING DIAGRAM


E151681E03


INSPECTION PROCEDURE

1.CHECK HEADLIGHT
  1. Check the operation of LO-beam headlights and HI-beam headlights.

    OK:
    LO-beam headlights and HI-beam headlights operate normally.



NG
GO TO PROBLEM SYMPTOMS TABLE (Click here)
OK


2.INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY


    A137364E18
  1. Remove the engine room junction block assembly from the engine room relay block.

  1. Connect the positive (+) lead from the battery to terminal 2G-1.

  1. Connect the negative (-) lead from the battery to terminal 2D-8 and 2E-11.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    2B-4 - Battery negative
    Always
    8.47 to 12.6 V
    2B-5 - Battery negative
    Always
    8.47 to 12.6 V



NG
REPLACE ENGINE ROOM JUNCTION BLOCK ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)