Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > Fuel Injector Circuit

for Preparation Click here


DESCRIPTION

The fuel injectors are located on the intake manifold. They inject fuel into the cylinders based on the signals from the ECM.

WIRING DIAGRAM


A172778E01


A172779E01


INSPECTION PROCEDURE

1.CHECK FUEL INJECTOR ASSEMBLY (POWER SOURCE)


    A157859E14
  1. Disconnect the fuel injector assembly connector.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    B13-2 - Body ground
    Ignition switch on (IG)
    9 to 14 V
    B14-2 - Body ground
    Ignition switch on (IG)
    9 to 14 V
    B15-2 - Body ground
    Ignition switch on (IG)
    9 to 14 V
    B16-2 - Body ground
    Ignition switch on (IG)
    9 to 14 V
    B17-2 - Body ground
    Ignition switch on (IG)
    9 to 14 V
    B18-2 - Body ground
    Ignition switch on (IG)
    9 to 14 V

  1. Turn the ignition switch off.

  1. Reconnect the fuel injector assembly connector.



NG
Go to step 4
OK


2.INSPECT FUEL INJECTOR ASSEMBLY
  1. Inspect the injector assembly (Click here).



NG
REPLACE FUEL INJECTOR ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (FIEL INJECTOR ASSEMBLY - ECM)


    A157859E14
  1. Disconnect the fuel injector connector (of the misfiring cylinder).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Cylinder
    Tester Connection
    Switch Condition
    Specified Condition
    No. 1
    B13-2 - Body ground
    Ignition switch on (IG)
    11 to 14 V
    No. 2
    B14-2 - Body ground
    Ignition switch on (IG)
    11 to 14 V
    No. 3
    B15-2 - Body ground
    Ignition switch on (IG)
    11 to 14 V
    No. 4
    B16-2 - Body ground
    Ignition switch on (IG)
    11 to 14 V
    No. 5
    B17-2 - Body ground
    Ignition switch on (IG)
    11 to 14 V
    No. 6
    B18-2 - Body ground
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (FUEL INJECTOR ASSEMBLY - ECM)
OK

REPLACE ECM (Click here)  

4.INSPECT FUSE (INJ NO. 2 FUSE)


    A168235E06
  1. Remove the INJ No. 2 fuse from engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    INJ No. 2 fuse
    Always
    Below 1 Ω

  1. Reinstall the INJ No. 2 fuse.



NG
REPLACE FUSE
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (INTEGRATION RELAY (IG2 RELAY) - FUEL INJECTOR ASSEMBLY)