DTC P011B Engine Coolant Temperature / Intake Air Temperature Correlation |
| DTC No. | DTC Detection Condition | Trouble Area |
| P011B | When conditions (a), (b), (c), (d) and (e) are met (2 trip detection) (a) Battery voltage is 10.5 V or more (b) 21 seconds after the engine has been started after the ignition switch has been off for more than 7 hours (c) The minimum intake air temperature after the engine has been started is more than -10°C (14°F) (d) The average coolant temperature before the engine is started is more than -10°C (14°F) (e) The difference between the readings of the ECT and IAT is greater than 20°C (68°F) |
|

| Related DTCs | P011B: ECT / IAT sensor correlation |
| Required Sensors / Components (Main) | ECT / IAT sensor |
| Required Sensors / Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | 21 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| All of following conditions are met | Conditions 1 and 2 |
| 1. All of following conditions are met | Conditions (a), (b), (c) and (d) |
| (a) After ignition switch ON and engine not running time | Less than 20 seconds |
| (b) Soak Time | 7 hours or more |
| (c) Battery voltage | 10.5 V or more |
| (d) Time after engine start | 21 seconds or more |
| 2. Either of the following conditions is met | Conditions (a) and (b) |
| (a) After engine start minimum IAT | -10°C (14°F) or more |
| (b) Before engine start ECT | -10°C (14°F) or more |
| Deviated ECT minus Deviated IAT | Less than -20°C (-4°F) or more than 20°C (68°F) |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION P011B) |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P011B | A |
| P011B and other DTCs | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (INTAKE AIR TEMPERATURE) |
Leave the vehicle for 7 hours or more.
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Intake Air.
Read the value displayed on the tester.
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (COOLANT TEMPERATURE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
|
| ||||
| OK | ||
| ||