Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/ Smart Key System)

THEFT DETERRENT SYSTEM (w/ Smart Key System) > ECU Power Source Circuit


DESCRIPTION

This circuit provides power for main body ECU operation.

WIRING DIAGRAM


B177823E04


INSPECTION PROCEDURE

1.CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU (POWER SOURCE))


    B177819E04
  1. Disconnect the 1D junction block connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    1D-16 - Body ground
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - BODY GROUND)


    B177820E05
  1. Disconnect the 1F and 1M junction block connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    1F-10 - Body ground
    Below 1 Ω
    1M-9 - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)