THEFT DETERRENT SYSTEM (w/o Smart Key System) > ECU Power Source Circuit |

| 1.CHECK INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU (POWER SOURCE)) |
![]() |
Disconnect the 1D junction block connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 1D-10 - Body ground | 11 to 14 V |
| 1D-16 - Body ground | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - BODY GROUND) |
![]() |
Disconnect the 1F and 1M junction block connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 1F-10 - Body ground | Below 1 Ω |
| 1M-9 - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||