DTC B1787 Rear Occupant Classification Sensor LH Collision Detection |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1787 |
|
|

| 1.PERFORM ZERO POINT CALIBRATION |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Using Techstream, perform "zero point calibration" (Click here).
|
| ||||
| OK | |
| 2.PERFORM SENSITIVITY CHECK |
Using Techstream, perform "sensitivity check" (Click here).
|
| ||||
| OK | |
| 3.CHECK DTC |
Turn the ignition switch on (IG).
Clear the DTCs stored in the occupant classification ECU (Click here).
Clear the DTCs stored in the center airbag sensor assembly (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPLACE FRONT SEAT ASSEMBLY RH |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery.
Replace the front seat assembly RH (Click here for power seat or Click here for manual seat).
| NEXT | |
| 5.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Using Techstream, perform "zero point calibration" (Click here).
|
| ||||
| OK | |
| 6.PERFORM SENSITIVITY CHECK |
Using Techstream, perform "sensitivity check" (Click here).
|
| ||||
| OK | |
| 7.CHECK DTC |
Turn the ignition switch on (IG).
Clear the DTCs stored in the occupant classification ECU (Click here).
Clear the DTCs stored in the center airbag sensor assembly (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 8.REPLACE OCCUPANT CLASSIFICATION ECU |
Turn the ignition switch off.
Disconnect the negative (-) terminal cable from the battery.
Replace the occupant classification ECU (Click here).
| NEXT | |
| 9.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Using Techstream, perform "zero point calibration" (Click here).
| NEXT | |
| 10.PERFORM SENSITIVITY CHECK |
Using Techstream, perform "sensitivity check" (Click here).
| NEXT | ||
| ||