Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION SYSTEM

DTC    B1796    Sleep Operation Failure of Occupant Classification ECU

for Preparation Click here


DESCRIPTION

In sleep mode, the occupant classification ECU reads the condition of each sensor while the ignition switch is off.
In this mode, if occupant classification ECU detects an internal malfunction, DTC B1796 is output.

DTC No.
DTC Detection Condition
Trouble Area
B1796
  1. Occupant classification ECU malfunction
  1. Occupant classification ECU

HINT:
When DTC B1650/32 is detected as a result of troubleshooting for the AIRBAG SYSTEM, check the DTCs stored in the occupant classification ECU. When DTC B1796 is output, perform troubleshooting for the DTC.


INSPECTION PROCEDURE

1.CHECK DTC
  1. Turn the ignition switch on (IG).

  1. Clear the DTCs stored in the occupant classification ECU (Click here).

  1. Clear the DTCs stored in the center airbag sensor assembly (Click here).

  1. Turn the ignition switch off, and wait for at least 10 seconds.

  1. Turn the ignition switch on (IG).

  1. Check for DTCs (Click here).

    OK:
    DTC B1796 is not output.

    HINT:
    Codes other than DTC B1796 may be output at this time, but they are not related to this check.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.REPLACE OCCUPANT CLASSIFICATION ECU
  1. Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery.

  1. Replace the occupant classification ECU (Click here).


NEXT


3.PERFORM ZERO POINT CALIBRATION
  1. Connect the negative (-) terminal cable to the battery.

  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Using Techstream, perform "zero point calibration" (Click here).

    OK:
    "Zero Point Calibration is complete." is displayed.


NEXT


4.PERFORM SENSITIVITY CHECK
  1. Using Techstream, perform "sensitivity check" (Click here).

    Standard:
    27 to 33 kg (59.52 to 72.75 lb)


NEXT

END