POWER WINDOW CONTROL SYSTEM > Remote Up / Down Function does not Operate |

| 1.CHECK POWER WINDOW MASTER SWITCH |
![]() |
Turn the window lock switch OFF and operate the switches on the master switch. Check that the remote UP / DOWN function operates normally.
|
| ||||
| OK | ||
| ||
| 2.CHECK MANUAL UP / DOWN FUNCTION |
Check that the passenger door power window manual UP / DOWN function operates normally.
|
| ||||
| OK | ||
| ||
| 3.HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH - BATTERY AND BODY GROUND) |
![]() |
Disconnect the M1 connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M1-6 (B) - Body ground | Ignition switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| M1-1 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT POWER WINDOW MASTER SWITCH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (B) - 16 (U) 15 (D) - 1 (E) | UP (Passenger side) | Below 1 Ω |
| 6 (B) - 15 (D) 16 (U) - 1 (E) | DOWN (Passenger side) | Below 1 Ω |
| 6 (B) - 12 (U) 13 (D) - 1 (E) | UP (Rear LH) | Below 1 Ω |
| 6 (B) - 13 (D) 12 (U) - 1 (E) | DOWN (Rear LH) | Below 1 Ω |
| 6 (B) - 10 (U) 18 (D) - 1 (E) | UP (Rear RH) | Below 1 Ω |
| 6 (B) - 18 (D) 10 (U) - 1 (E) | DOWN (Rear RH) | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (MASTER SWITCH - FRONT PASSENGER, REAR LH/RH SWITCH) |
![]() |
Front passenger side:
Disconnect the M1 and G7 connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M1-16 (U) - G7-5 (SU) | Always | Below 1 Ω |
| M1-15 (D) - G7-2 (SD) | Always | Below 1 Ω |
| M1-16 (U) - Body ground | Always | 10 kΩ or higher |
| M1-15 (D) - Body ground | Always | 10 kΩ or higher |
![]() |
for Rear LH side:
Disconnect the M1 and K2 connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M1-12 (U) - K2-5 (SU) | Always | Below 1 Ω |
| M1-13 (D) - K2-2 (SD) | Always | Below 1 Ω |
| M1-12 (U) - Body ground | Always | 10 kΩ or higher |
| M1-13 (D) - Body ground | Always | 10 kΩ or higher |
![]() |
for Rear RH side:
Disconnect the M1 and J2connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M1-10 (U) - J2-5 (SU) | Always | Below 1 Ω |
| M1-18 (D) - J2-2 (SD) | Always | Below 1 Ω |
| M1-10 (U) - Body ground | Always | 10 kΩ or higher |
| M1-18 (D) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||