Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Driver Side Power Window does not Operate with Power Window Master Switch

for Preparation Click here


DESCRIPTION

If the manual UP / DOWN and AUTO DOWN functions do not operate, a malfunction may exist in the power window master switch, power window regulator motor or wire harness.

WIRING DIAGRAM


B175980E08


INSPECTION PROCEDURE

1.INSPECT POWER WINDOW MASTER SWITCH (DRIVER SWITCH)


    B164359E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    8 (U) - 1 (E) - 4 (A)
    Auto UP
    Below 1 Ω
    8 (U) - 1 (E)
    Manual UP
    Below 1 Ω
    5 (D) - 1 (E)
    Manual DOWN
    Below 1 Ω
    4 (A) - 5 (D) - 1 (E)
    Auto DOWN
    Below 1 Ω



NG
REPLACE POWER WINDOW MASTER SWITCH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (MASTER SWITCH - MOTOR (DRIVER SIDE))


    B175976E07
  1. Disconnect the M1 and H1 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    M1-8 (U) - H1-10 (UP1)
    Always
    Below 1 Ω
    M1-4 (A) - H1-4 (AUTO)
    Always
    Below 1 Ω
    M1-5 (D) - H1-7 (DWN1)
    Always
    Below 1 Ω
    M1-8 (U) - Body ground
    Always
    10 kΩ or higher
    M1-4 (A) - Body ground
    Always
    10 kΩ or higher
    M1-5 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)


    B172587E01
  1. Remove the power window regulator motor (Click here).

    1. Apply battery voltage to the motor connector according to the table below.

      NOTICE:
      Do not apply battery voltage to any terminals except terminals 1, 2, 4, 7, 9 and 10.

      OK:
      Switch Condition
      Measurement Condition
      Specified Condition
      Manual Operation
      Battery positive (+) → Terminal 2 (B), 9 (LIN)
      Battery negative (-) → Terminal 1 (E), 7 (DWN1)
      Motor gear rotates counterclockwise
      Battery positive (+) → Terminal 2 (B), 9 (LIN)
      Battery negative (-) → Terminal 1 (E), 10 (UP1)
      Motor gear rotates clockwise
      Auto Operation
      Battery positive (+) → Terminal 2 (B), 9 (LIN)
      Battery negative (-) → Terminal 1 (E), 4 (AUTO), 7 (DWN1)
      Motor gear rotates counterclockwise
      Battery positive (+) → Terminal 2 (B), 9 (LIN)
      Battery negative (-) → Terminal 1 (E), 4 (AUTO), 10 (UP1)
      Motor gear rotates clockwise



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side) (Click here)
OK

REPLACE POWER WINDOW MASTER SWITCH (Click here)