Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF FRONT SHOCK ABSORBER


    C149517E01
  1. Position the front shock absorber assembly level with the piston rod fully extended. Using a drill, make a hole in the cylinder between A and B as shown in the illustration to discharge the gas inside.

    NOTICE:
    1. The gas is colorless, odorless, and nonpoisonous.
    2. Be careful when drilling because shards of metal may fly about, so always use the proper safety equipment.