FRONT SHOCK ABSORBER > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH |
![]() |
Remove the nut, and the front wiper arm and blade assembly LH.
| 3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH |
![]() |
Remove the nut, and the front wiper arm and blade assembly RH.
| 4. LOOSEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT |
![]() |
Loosen the front support to front shock absorber nut of the front shock absorber.
| 5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
![]() |
Disengage the 2 claws and disconnect the front fender to cowl side seal LH.
![]() |
Disengage the 2 claws and disconnect the front fender to cowl side seal RH.
Remove the 2 clips.

Disengage the 20 claws and remove the cowl top ventilator louver sub-assembly.
| 6. REMOVE WINDSHIELD WIPER MOTOR AND LINK |
![]() |
Disconnect the connector.
Remove the 4 bolts, and the windshield wiper motor and link assembly.
| 7. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY |
![]() |
Disengage the 4 clamps and separate the wiper wire harness from the outer cowl top panel sub-assembly.
![]() |
Remove the 8 bolts, 6 nuts, and the outer cowl top panel sub-assembly.
| 8. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the bolt and clamp, and separate the front speed sensor and front flexible hose.
| 9. SEPARATE FRONT STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the front stabilizer link assembly from the front shock absorber.
| 10. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() |
Support the front axle using a jack and wooden block.
![]() |
Remove the 2 bolts and 2 nuts, and separate the front shock absorber with coil spring (lower side) from the steering knuckle.
![]() |
Remove the nut and 2 spacers on the upper side of the front shock absorber with coil spring.
| 11. SECURE FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() |
As shown in the illustration, secure the front shock absorber with coil spring in a vise using aluminum plates by clamping onto a double nutted bolt affixed to the bracket at the bottom of the absorber.
| 12. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT |
![]() |
Using SST, compress the front coil spring.
Check that the front coil spring is fully compressed.
![]() |
Remove the front support to front shock absorber nut.
| 13. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY |
| 14. REMOVE FRONT SUSPENSION SUPPORT BEARING |
| 15. REMOVE FRONT COIL SPRING UPPER SEAT |
| 16. REMOVE FRONT COIL SPRING UPPER INSULATOR |
| 17. REMOVE FRONT COIL SPRING |
| 18. REMOVE FRONT SPRING BUMPER |
| 19. REMOVE FRONT COIL SPRING LOWER INSULATOR |